PLAYGROYND’S ENTRANCE DOOR 0020-354

0020-354

 

The wooden entrance is 260X230 cm. It consists of two wooden columns 9X9 cm and 225 cm high.

At the top of the columns with 8×80 screws are wooden beams of 4.5x15cm and 260cm long with curved edges.

On them are applied 11 vertically 4,5x15x50 cm wood with 8×120 screws.

On the horizontal beams and with the help of a chain there is a hanging wooden plate in dimensions according to the requirements of the customer. The plate may be embossed. The entrance gate consists of two sheets made of two 4.5x9x90 cm horizontal beams resting on 6 vertical 4.5×9 cm cross-section timbers with curved upper edges and variable length gradually increasing from edge to center.

TIMBER

The wood used is composite laminated Swedish pine timber, in accordance with EN 351. It is manufactured with special compound (welding of wood) in various sections depending on the intended use.

COMPOSITE wood is 40% stronger than whole wood. It has a strength of 360 kp / m2 and a specific weight of about 480 kg / m3.

 

It contains about 15% moisture

Contains minimal juices (resin) compared to other pine family trees in other countries (weather in northern Sweden up to -25 ° C)

It has thermal conductivity s = 0.10 Kcal / Mho and sound insulation 3.5 times greater than concrete or brick of equal thickness.

It has antimagnetic properties and is a poor conductor of electricity

It is resistant to fire and is classified in categories F30 and F60 (by DIN 4120) according to its cross-section. When the outer part of the cross-section burns, its interior protects and retains its durability.

It is processed just like commercial wood

It retains its shape and distorts or creates minimal fractures

Annual wood rings are usually perpendicular to the long side of the cross-section with a significant increase in the mechanical strength of this surface, if applied to floors.

All corners of the wood are planed with a radius of about 5 mm.

METALLIC ELEMENTS

The metallic elements used in the manufacture of the equipment (screws, connectors, etc.) are made of metals either thermo-galvanized or electro-galvanized, where the surface preparation has been preceded by sandblasting or stainless steel. The dimensions and cross-sections of the metallic elements are sufficient to accommodate (with an appropriate safety factor) the loads for which they have been designed to withstand corrosion and adverse weather conditions.

PAINTS

The varnishes and the colors that protect the wooden parts are specially designed for the climate of our country (temperature changes, open or closed areas etc.) are completely harmless to the users (they do not contain lead, chromium, cadmium and other heavy metals). ) and give great durability to our constructions.

PACKING

The following procedure is used for fixing the equipment:

At this point where the column is to be placed, an 80 cm deep pit is opened. about 60cm in diameter. Then, once the column is inserted, the pit is filled with frusto-concreted concrete until it reaches 20 cm. from the surface of the ground, where it is covered with soil.

Only ground irons, which hold each column at a distance of about 10 cm from the ground, are prevented on the ground in order to prevent the wood from corroding the soil moisture.

All production work processes for the processing of raw materials are carried out according to:

 

ISO 9001: 2015 quality system,

The ISO 14001: 2015 Environmental Management System