SEESAW 0010-259N
The metal seesaw is made of a hot rolled laminate Ø 2½ 3 mm thick and 250 cm long with two ends of hot rolled laminated sheets Ø ¾ ″ shaped in a circular shape of 26 cm in diameter. Inside there are 26×3 cm cross-shaped blades for seating 20mm thick seabed and 25.5 cm in diameter.
There are also metal handles on the two ends of the saw to hold users. These handles are hot-rolled laminates formed in a circular shape of 26 cm in diameter.
In the center of the body of the saw and perpendicular to it, there are two sheets of hot rolled Ø 2 ½ “and 80 cm high, which pierce a shaft with the bearing and form the basis of the oscillation of the saw.
Underneath each seat there are two sections of rectangular cross-section rubber to absorb vibration when using the saw.
PLASTIC INFORMATION
The plastic components required to manufacture the equipment are highly resistant to UV radiation and adverse weather conditions. Preferred are recyclable materials such as polyethylene (PE) or polypropylene (PP). Specifically all screws protruding from the equipment over 5 mm are covered with polypropylene (PP) plastic plugs. They are also safe for the safety and health of children.
METALLIC ELEMENTS
The metallic elements used in the manufacture of the equipment (screws, joints, etc.) are made of metals either thermo-galvanized or electro-galvanized, where the surface preparation has been preceded by sandblasting or stainless steel. The dimensions and cross-sections of the metallic elements are sufficient to receive (with an appropriate safety factor) the loads for which they have been designed to withstand corrosion and adverse weather conditions.
PAINTS
The varnishes and the colors that protect the wooden parts are specially designed for the climate of our country (temperature changes, open or closed areas etc.) are absolutely harmless to the users (they contain no lead, chromium, cadmium and other heavy metals). ) and give great strength to our constructions.
For their anticorrosive protection, the metal parts are processed for polishing, followed by a coating of polyzinc (zinc) and then electrostatic, two-layer polyester powder coating.
PACKING
The following procedure is used for fixing the equipment:
At this point where the column is to be installed, a pit about 80 cm deep and 60 cm in diameter is opened. Then, after the column is inserted, the pit is filled with frusto-concreted concrete until it reaches 10 cm. from the ground surface, where it is covered with soil.
Only ground irons, which hold each column at a distance of about 10 cm from the ground, are prevented on the ground in order to prevent the wood from being corroded by soil moisture.
All production work processes for the processing of raw materials are carried out according to:
- EN 1176 standards 1-6,
- ISO 9001: 2015 quality system
- The ISO 14001: 2015 environmental management system
