BASKETBALL STAND 0030-403
0030-403
The trunk of the basket consists of three parts and is made of 3 mm thick sheet steel which, after being rubbed, is welded to a 1 ½ ”steel frame for ultimate stability and rigidity in construction. The edges created by the strand are rounded to avoid accidents.
The cross-section of the base of the basket is 38X15 cm, while at 221,5 cm the cross section becomes 19X15 cm. The second section of the basket ends at 200 cm in length, 15×15 cm, while the third and last section has 13×15 cm cross section 57 cm. At the point where the basketball cross section ends at 15X15 cm there are two cross-section brackets ¾ ”mounted for the firm support of the board.
The dashboard is made of a 50X30 corner and measures 105X180 cm. In the center of the metal frame and at equal distances from its vertical sides, a second smaller metal frame 59×45 cm is made, which is 30 cm from the bottom of the frame. from plexi glass dimensions 105×180 cm and 12 mm thick it is mounted on metal corners with screws and between it and metal corners an elastic membrane is inserted to absorb the vibrations.
The hoop is made of iron rod Ø 20 with an inner net diameter of 45 cm and is mounted on the mounting base of the panel with screws, which pass through special brass cylindrical sockets of the panel and fasten to the plates joining the inner small frame with the perimeter frame. labeling. At the bottom of the hoop there are 12 hooks to support the net, which are designed to prevent accidents (it is impossible to trap the players’ hands in it).
The height of the hoop is 305 cm above the ground
The base of the basket is 100x70x150 cm and has a maximum height of 30 cm and is made of 4 mm thick sheet metal.
The front face of the base is 30×100 cm, while the rear is 16×70 cm.
The base has a metal tube of Ø 2 99 and a diameter of 99 cm and three other Ø ½ ”tubes of similar length. At the front it has two wheels Ø 200 and one at the rear, which is rotatable to make it easier to move.
Also on the upper surface of the base there is a canister of sand to prevent the basket from tipping over. The box measures 76×58 cm and is 61 cm high.
Also on the base besides the counter there is a handle made of 1 δια cross-section pipe 75X60 cm.
METALLIC ELEMENTS
The metallic elements used in the manufacture of the equipment (screws, connectors, etc.) are made of metals either thermo-galvanized or electro-galvanized, where the surface preparation has been preceded by sandblasting or stainless steel. The dimensions and cross-sections of the metallic elements are sufficient to accommodate (with an appropriate safety factor) the loads for which they have been designed to withstand corrosion and adverse weather conditions.
PAINTS
For their anticorrosive protection, the metal parts are processed to release them, followed by a coating of polyzinc (zinc) and then electrostatic, two-layer polyester powder coating.
All production work processes for the processing of raw materials are carried out according to:
The ISO 9001: 2015 quality system
The ISO 14001: 2015 Environmental Management System
