BASKETBALL STAND 0030-407
0030-407
The trunk of the basket consists of three parts and is made of 4 mm thick sheet steel which, after being rubbed, is welded to a Ø ¾ ”steel frame for ultimate stability and rigidity in construction. The first part starts at a cross section of 35X20 cm and ends at a cross section of 20X20 cm at a height of 225 cm. Then follows the second part with a slope, which starts at a cross section of 20X20 cm and ends at a cross section of 20X15 cm and a length of 200 cm. The third part that follows starts from a cross section 20×15 cm and ends up a cross section 20×10 cm and a length of 95 cm.
The edges created by the strand are rounded to avoid accidents.
In the third section of the basket and at a distance of 75 cm from the mounting point of the dashboard, 30×3 mm four-hole tires are welded to which the brackets are connected. Also at the upper end of the trunk there is a 60X6 blade to support the dashboard on the trunk.
The straps are made of a 132 cm long tube starting from the third part of the trunk and ending at the two upper edges of the dashboard.
The board is made of a 50×30 corner and measures 105×180 cm.
In the center of the metal frame and at equal distances from its vertical sides a second smaller metal frame 59×45 cm is made, which is 30 cm from the bottom of the frame.
The plexi glass panel 105×180 cm and 12 mm thick is mounted on metal corners with screws and an elastic membrane is inserted between it and the metal corners to absorb vibration.
The hoop is made of iron rod Ø 20 with an inner net diameter of 45 cm and is mounted on the mounting base of the panel with screws, which pass through special brass cylindrical sockets of the panel and fasten to the plates joining the inner small frame with the perimeter frame. labeling. At the bottom of the rim there are 12 hooks to support the net, which are designed to prevent accidents.
The height of the hoop is 305 cm above the ground.
The lower body of the basket ends at the base of the basket. The base is 52×34 cm and consists of a pair of angles 70x70x7mm and 52cm long and a pair of angles 70x70x7mm and 20cm with seven Ø Ø holes (three on each side and one on the back) through which are then passed through the 30-foot screws on the metal shoe (hook), which is already fixed to the ground and consists of four tubes Ø 2 ”and 60 cm in length which are connected to a similar structure to the base.
METALLIC ELEMENTS
The metallic elements used in the manufacture of the equipment (screws, connectors, etc.) are made of metals either thermo-galvanized or electro-galvanized, where the surface preparation has been preceded by sandblasting or stainless steel. The dimensions and cross-sections of the metallic elements are sufficient to accommodate (with an appropriate safety factor) the loads for which they have been designed to withstand corrosion and adverse weather conditions.
PAINTS
For their anticorrosive protection, the metal parts are processed to release them, followed by a coating of polyzinc (zinc) and then electrostatic, two-layer polyester powder coating.
All production work processes for the processing of raw materials are carried out according to:
The ISO 9001: 2015 quality system
The ISO 14001: 2015 Environmental Management System
