BASKETBALL STAND 0030-408
0030-408
SE 13-01
The trunk of the basket consists of two parts and is made of 3 mm thick sheet metal which is sanded. The first part starts at a cross section of 35X15 cm and ends at a cross section of 25X15 cm at a height of 210 cm. Then follows the second part with a gradient of about 120 °, which starts at a cross section of 25X15 cm and ends at a cross section of 15X15 cm and a length of 125 cm. created by the strand are rounded to avoid accidents.
In the second part of the basket and at a distance of 95 cm from the mounting point of the dashboard, 30×3 mm four-hole tires with which the brackets are connected, are welded. Also at the upper end of the trunk there is a 60X6 blade to support the dashboard on the trunk.
The straps are made of 195 ”tube and 195 cm long which start from the third part of the trunk and end at the two upper edges of the dashboard.
The dashboard is made of a 50X30 angle and is 90×120 cm. In the center of the metal frame and at equal distances from its vertical sides, a second smaller metal frame 45×35 cm is made. corners with milling screws and between it and the metal corners a 50X3 mm elastic film is inserted to absorb the vibrations.
The hoop is made of iron rod F 20 with an inner net diameter of 45 cm and is mounted on the mounting base of the panel with 4 M10 bolts, which pass through special brass cylindrical sockets of the board and screw into the plates joining the inner small frame with the perimeter marking framework. At the bottom of the rim there are 12 hooks to support the net, which are designed to prevent accidents.
The height of the hoop is 275 cm above the ground.
The lower body of the basket ends at the base of the basket. The base is 50×30 cm and consists of a pair of angles 70x70x7mm and 50cm long and a pair of angles 70x70x7mm and 16cm with five ¾ ”holes (two on each side and one on the back) through which then pass the 30-foot screws on the metal shoe (hook), which is already fixed to the ground and consists of four 1 ½ ”and 45 cm long tubes that are connected in a similar construction to the base.
METALLIC ELEMENTS
The metallic elements used in the manufacture of the equipment (screws, connectors, etc.) are made of metals either thermo-galvanized or electro-galvanized, where the surface preparation has been preceded by sandblasting or stainless steel. The dimensions and cross-sections of the metallic elements are sufficient to accommodate (with an appropriate safety factor) the loads for which they have been designed to withstand corrosion and adverse weather conditions.
PAINTS
The varnishes and paints that protect the wooden parts are specially designed for the climate of our country and are absolutely harmless to the users (they do not contain lead, chromium, cadmium or other heavy metals) and give high strength to our constructions.
For their anticorrosive protection, the metal parts are processed to release them, followed by a coating of polyzinc (zinc) and then electrostatic, two-layer polyester powder coating.
All production work processes for the processing of raw materials are carried out according to:
The ISO 9001: 2015 quality system
The ISO 14001: 2015 Environmental Management System
