SP403 Hippo

SPRINGS 10-06-07

 

10-06-07

The wooden animals with a spring consist of two main parts:

 

The main wooden body

The spring and the base

The main body consists of two sections of 18 mm hippo-shaped birch plywood and three ½’’ and 37.5 cm long metal tubes that hold the two plywood and act as handgrips and mounting brackets for child.

A third colored birch plywood is used as a seat. The seat measures 25 x 52 cm and a thickness of 22 mm. It has a rectangular shape while on its two small sides it forms semicircles.

The oscillation spring is 40 cm high and is placed at the bottom of the seat. Below the spring there is a metal flange with a diameter of 30 cm and a thickness of 1 cm. Below the flange are mounted four 5/8 cross sections that form the base for mounting.

PAINTED PLYWOOD BIRCH

The plywood elements required for our constructions are approximately 20 mm thick and are made of 1.5 mm thick laminated wood with pressurized heat sealant using non-toxic phenolic base resins. They are painted with water-soluble paints to which no seals, solvents or dyes containing lead, chromium, cadmium or other heavy metals have been attached. The colors are also very resistant to adverse weather conditions.

The above plywood sheets are in accordance with EN 314-2. The quality of the plywood is such that no further processing is required before painting, such as, for example, stocking, and reliefs and themes can be engraved.

PLASTIC INFORMATION

The plastic components required to manufacture the equipment are highly resistant to UV radiation and adverse weather conditions. Preferred are recyclable materials such as polyethylene (PE) or polypropylene (PP). Specifically all screws protruding from the equipment over 5 mm are covered with polypropylene (PP) plastic plugs. They are also safe for the safety and health of children.

METALLIC ELEMENTS

The metallic elements used in the manufacture of the equipment (screws, connectors, etc.) are made of metals either thermo-galvanized or electro-galvanized, where the surface preparation has been preceded by sandblasting or stainless steel. The dimensions and cross-sections of the metallic elements are sufficient to accommodate (with an appropriate safety factor) the loads for which they have been designed to withstand corrosion and adverse weather conditions.

PAINTS

The varnishes and the colors that protect the wooden parts are specially designed for the climate of our country (temperature changes, open or closed areas etc.) are completely harmless to the users (they do not contain lead, chromium, cadmium and other heavy metals). ) and give great durability to our constructions.

PACKING

The following procedure is used for fixing the equipment

At this point where the column is to be installed, a pit about 80 cm deep and 60 cm in diameter is opened. Then, once the column is inserted, the pit is filled with fractured cone-shaped concrete until it reaches 10 cm from the ground surface, where it is covered with soil.

Only ground irons, which hold each column at a distance of about 10 cm from the ground, are prevented on the ground in order to prevent the wood from being corroded by soil moisture.

All production work processes for the processing of raw materials are carried out according to:

 

EN 1176 standards 1-6,

The ISO9001: 2015 quality system

The environmental management system ISO14001: 2015